To Next Page

To Previous Page

Configuring and Monitoring Port Security

Reading Intrusion Alerts and Resetting Alert Flags

Log Listing with

Security Violation

Detected

Log Listing with No

Security Violation

Detected

Log Command

with

“security” for

Figure 13-18. Example of Log Listing With and Without Detected Security

Violations

From the Menu Interface: In the Main Menu, click on

4. Event Log and use

ext page and Prev page to review the Event Log contents.

For More Event Log Information. See “Using the Event Log To Identify

Problem Sources” in the “Troubleshooting” chapter of the Management and

Configuration Guide for your switch.

Web: Checking for Intrusions, Listing Intrusion

Alerts, and Resetting Alert Flags

1. Check the Alert Log by clicking on the Status tab and the [Overview] button.

If there is a “Security Violation” entry, do the following:

a. Click on the Security tab.

b. Click on

[Intrusion Log]. “Ports with Intrusion Flag” indicates any ports

for which the alert flag has not been cleared.

c. To clear the current alert flags, click on

[Reset Alert Flags].

To access the web-based Help provided for the switch, click on

[?] in the web

browser screen.

13-40

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General