EasyManuals Logo

HP PROCURVE 2910AL User Manual

HP PROCURVE 2910AL
594 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #432 background imageLoading...
Page #432 background image
Traffic/Security Filters and Monitors
Filter Types and Operation
Table 11-2. Multicast Filter Limits
Max-VLANs
Setting
Maximum # of Multicast Filters (Static and
IGMP Combined)
1 (the minimum) 420
8 (the default) 413
32 or higher 389
Notes Per-Port IP Multicast Filters. The static multicast filters described in this
section filter traffic having a multicast address you specify. To filter all
multicast traffic on a per-VLAN basis, refer to the section titled “Configuring
and Displaying IGMP” in the chapter titled “Multimedia Traffic Control with
IP Multicast (IGMP)” in the Multicast and Routing Guide for your switch.
IP Multicast Filters. Multicast filters are configured using the Ethernet
format for the multicast address. IP multicast addresses occur in the range of
224.0.0.0 through 239.255.255.255 (which corresponds to the Ethernet multi-
cast address range of 01005e-000000 through 01005e-7fffff). Any static Traffic/
Security filters configured with a multicast filter type and a multicast address
in this range will continue to be in effect unless IGMP learns of a multicast
group destination in this range. In this case, IGMP takes over the filtering
function for the multicast destination address(es) for as long as the IGMP
group is active. If the IGMP group subsequently deactivates, the static filter
resumes control over traffic to the multicast address.
Caution If Spanning Tree is enabled, then the MSTP multicast MAC address (0180c2-
000000) should not be filtered. (STP will not operate properly if the MSTP
multicast MAC address is filtered.)
Protocol Filters
This filter type enables the switch to forward or drop, on the basis of protocol
type, traffic to a specific set of destination ports on the switch. Filtered
protocol types include:
AppleTalk NetBEUI
ARP SNA
IPX
11-16

Table of Contents

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

HP PROCURVE 2910AL Specifications

General IconGeneral
ModelHP ProCurve 2910al
Switching Capacity128 Gbps
Throughput95.2 Mpps
ManagementWeb, CLI, SNMP
Jumbo Frame SupportYes
ManageableYes
Power100-240 VAC
Power SupplyInternal
Operating Temperature0°C to 45°C (32°F to 113°F)
StackingYes
MAC Address Table Size32000 entries
Routing ProtocolRIP, OSPF
FeaturesIPv6, VLAN, QoS, ACLs
Operating Humidity15% to 95% non-condensing
Uplink Ports4
Power over EthernetYes (PoE+ models available)

Related product manuals