To Next Page

To Previous Page

Configuring Port-Based and User-Based Access Control (802.1X)

Messages Related to 802.1X Operation

Table 12-6. 802.1X Operating Messages

Message Meaning

Port

< port-list > is not an authenticator. The ports in the port list have not been enabled as 802.1X

authenticators. Use this command to enable the ports as

authenticators:

ProCurve(config)# aaa port-access

authenticator e 10

Port

< port-list > is not a supplicant. Occurs when there is an attempt to change the supplicant

configuration on a port that is not currently enabled as a

supplicant. Enable the port as a supplicant and then make

the desired supplicant configuration changes. Refer to

“Enabling a Switch Port as a Supplicant” on page 12-51.

No server(s) responding. This message can appear if you configured the switch for

EAP-RADIUS or CHAP-RADIUS authentication, but the

switch does not receive a response from a RADIUS server.

Ensure that the switch is configured to access at least one

RADIUS server. (Use show radius.) If you also see the

message Can’t reach RADIUS server <

x.x.x.x >, try the suggestions listed for that message

(page 5-50).

LACP has been disabled on 802.1X port(s).

To maintain security, LACP is not allowed on ports

configured for 802.1X authenticator operation. If you

configure port security on a port on which LACP (active or

passive) is configured, the switch removes the LACP

configuration, displays a notice that LACP is disabled on the

port(s), and enables 802.1X on that port.

Error configuring port

< port-number >: Also, the switch will not allow you to configure LACP on a

LACP and 802.1X cannot be run together.

port on which port access (802.1X) is enabled.

12-75

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General