Traffic/Security Filters and Monitors
Configuring Traffic/Security Filters
Only one filter for a particular protocol type can be configured at any one time.
For example, a separate protocol filter can be configured for each of the
protocol types listed above, but only one of those can be an IP filter. Also, the
destination ports for a protocol filter can be on different VLANs.
You can configure up to seven protocol filters.
Configuring Traffic/Security Filters
Use this procedure to specify the type of filters to use on the switch and
whether to forward or drop filtered packets for each filter you specify.
1. Select the static filter type(s).
2. For inbound traffic matching the filter type, determine the filter action
you want for each outbound (destination) port on the switch (forward or
drop). The default action for a new filter is to forward traffic of the
specified type to all outbound ports.
3. Configure the filter.
4. Use show filter (page 11-23) to check the filter listing to verify that you
have configured correct action for the desired outbound ports.
11-17
To Next Page
Loading...
Need help?
General