To Next Page

To Previous Page

RADIUS Authentication and Accounting

Configuring the Switch for RADIUS Authentication

3. Configure the Switch To Access a RADIUS Server

This section describes how to configure the switch to interact with a RADIUS

server for both authentication and accounting services.

Note If you want to configure RADIUS accounting on the switch, go to page 5-35:

“Configuring RADIUS Accounting” instead of continuing here.

Syntax: [no] radius-server host < ip-address >

Adds a server to the RADIUS configuration or (with no)

deletes a server from the configuration. You can configure

up to three RADIUS server addresses. The switch uses the

first server it successfully accesses. (Refer to “Changing

the RADIUS Server Access Order” on page 5-47.)

[auth-port < port-number >]

Optional. Changes the UDP destination port for authenti-

cation requests to the specified RADIUS server (host). If

you do not use this option with the radius-server host

command, the switch automatically assigns the default

authentication port number. The auth-port number must

match its server counterpart. (Default: 1812)

[acct-port < port-number >]

Optional. Changes the UDP destination port for account-

ing requests to the specified RADIUS server. If you do not

use this option with the radius-server host command, the

switch automatically assigns the default accounting port

number. The acct-port number must match its server coun-

terpart.(Default: 1813)

5-15

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General