Using Authorized IP Managers
Defining Authorized Management Stations
Menu: Viewing and Configuring IP Authorized
Managers
Only IPv4 is supported when using the menu to set the management access
method.
From the console Main Menu, select:
2. Switch Configuration …
6. IP Authorized Managers
ProCurve 22-Apr-2008 20:17:53
==========================- CONSOLE - MANAGER MODE -============================
Switch Configuration - IP Managers
Authorized Manager IP IP Mask Access Level Access Method
---------------------- ---------------------- ------------ -------------
10.10.240.2 255.255.255.255 Manager all
10.10.245.3 255.255.255.255 Operator ssh
10.10.246.200 255.255.255.255 Operator tftp
10.10.245.30 255.255.255.0 Operator ssh
1. Select Add to add an authorized manager
to the list.
Actions-> Back Add Edit Delete Help
Figure 14-1. Example of How to Add an Authorized Manager Entry
ProCurve 22-Apr-2008 20:17:53
==========================- CONSOLE - MANAGER MODE -============================
Switch Configuration - IP Managers
Authorized Manager IP: 10.10.245.3
IP Mask [255.255.255.255]:255.255.255.255
Access Level:Operator
Enter an Authorized Manager IP address here.
Help
Use the default mask to allow access by one
management device, or edit the mask to allow
access by a block of management devices. See
“Building IP Masks” on page 14-10.
Use the Space bar to select Manager or Operator
access.
Press [Enter], then [S] (for Save) to configure the
IP Authorized Manager entry.
Actions-> Back Add Edit Delete
Figure 14-2. Example of Edit Menu for Authorized IP Managers
14-5
To Next Page
Loading...
Need help?
General
