HP PROCURVE 2910AL User Manual

RADIUS Authentication and Accounting
Commands Authorization
Example Configuration on Cisco Secure ACS for MS Windows
It is necessary to create a dictionary file that defines the VSAs so that the
RADIUS server application can determine which VSAs to add to its user
interface. The VSAs will appear below the standard attributes that can be
configured in the application.
The dictionary file must be placed in the proper directory on the RADIUS
server. Follow these steps.
1. Create a dictionary file (for example, hp.ini) containing the HP VSA
definitions, as shown in the example below.
;[User Defined Vendor]
;
; The Name and IETF vendor code and any VSAs MUST be unique.
;
; One or more VSAs named (max 255)
;
; Each named VSA requires a definition section…
;
; Types are STRING, INTEGER, IPADDR
;
; The profile specifies usage, IN for accounting, OUT for
authorization,
; MULTI if more than a single instance is allowed per
RADIUS message.
; Combinations are allowed, e.g. "IN", "MULTI OUT",
"MULT IN OUT"
;
; Enumerations are optional for INTEGER attribute types
[User Defined Vendor]
Name=HP
IETF Code=11
VSA 2=Hp-Command-String
VSA 3=Hp-Command-Exception
[Hp-Command-String]
Type=STRING
Profile=IN OUT
[Hp-Command-Exception]
Type=INTEGER
5-30

HP PROCURVE 2910AL Specifications

General

Model	HP ProCurve 2910al
Switching Capacity	128 Gbps
Throughput	95.2 Mpps
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
Manageable	Yes
Power	100-240 VAC
Power Supply	Internal
Operating Temperature	0°C to 45°C (32°F to 113°F)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF
Features	IPv6, VLAN, QoS, ACLs
Operating Humidity	15% to 95% non-condensing
Uplink Ports	4
Power over Ethernet	Yes (PoE+ models available)