To Next Page

To Previous Page

RADIUS Authentication and Accounting

Commands Authorization

Profile=IN OUT

Enums=Hp-Command-Exception-Types

[Hp-Command-Exception-Types]

0=PermitList

1=DenyList

2. Copy the hp.ini dictionary file to c:\program files\cisco acs 3.2\utils (or

the \utils directory wherever acs is installed).

3. From the command prompt execute the following command:

c:\Program files\CiscoSecure ACS v3.2\utils>

csutil -addudv 0 hp.ini

The zero (0) is the slot number. You will see some processing messages:

Adding or removing vendors requires ACS services to be

re-started. Please make sure regedit is not running as

it can prevent registry backup/restore operations.

Are you sure you want to proceed? (Y or N) y

Parsing [.\hp.ini] for addition at UDV slot [0]

Stopping any running services

Creating backup of current config

Adding Vendor [HP} added as [RADIUS (HP)]

Done

Checking new configuration...

New configuration OK

Re-starting stopped services

4. Start the registry editor (regedit) and browse to

HKEY_LOCAL_MACHINE\software\cisco\CiscoAAA v3.2\NAS Vendors

tree.

Cisco adds the entry into this tree for each custom vendor. The id is 100

+ the slot number used in the previous command (100 + 0, as it was added

in slot 0). Look in the key to verify the vendor name and id.

5. Go to:

HKEY_LOCAL_MACHINE\software\cisco\CiscoAAAv3.2\

CSRadius\ExtensionPoints\002\AssociatedWithVendors

5-31

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General