RADIUS Authentication and Accounting
Commands Authorization
6. Right click and then select New > key. Add the vendor Id number that
you determined in step 4 (100 in the example).
7. Restart all Cisco services.
8. The newly created HP RADIUS VSA appears only when you configure an
AAA client (NAS) to use the HP VSA RADIUS attributes. Select Network
Configuration and add (or modify) an AAA entry. In the Authenticate
Using field choose RADIUS(HP) as an option for the type of security
control protocol.
9. Select Submit + Restart to effect the change. The HP RADIUS VSA
attributes will appear in Cisco ACS configurations, for example, “Interface
Configuration”, “Group Setup”, “User Setup”.
To enable the processing of the HP-Command-String VSA for RADIUS
accounting:
1. Select System Configuration.
2. Select Logging.
3. Select CSV RADIUS Accounting. In the Select Columns to Log section,
add the HP-Command-String attribute to the Logged Attributes list.
4. Select Submit.
5. Select Network Configuration. In the AAA Clients section, select an
entry in the AAA Client Hostname column. You will go to the AAA Client
Setup screen.
6. Check the box for Log Update/Watchdog Packets from this AAA
Client.
7. Click Submit + Restart. You should be able to see the HP-Command-
String attribute in the RADIUS accounting reports.
You can enter the commands you wish to allow or deny with the special
characters used in standard regular expressions (c, ., \, [list], [^list], *, ^, $).
Commands must be between 1-249 characters in length.
Example Configuration Using FreeRADIUS
1. Create a dictionary file (for example, dictionary.hp) containing HP VSA
definitions. An example file is:
5-32
To Next Page
Loading...
Need help?
General
