To Next Page

To Previous Page

Traffic/Security Filters and Monitors

Filter Types and Operation

This list shows the filter created

to block (drop) traffic from

source port 5 (workstation "X") to

destination port 7 (server "A").

Notice that the filter allows

traffic to move from source port

5 to all other destination ports.

Figure 11-3. The Filter for the Actions Shown in Figure 11-2

Named Source-Port Filters

You can specify named source-port filters that may be used on multiple ports

and port trunks. A port or port trunk can only have one source-port filter, but

by using this capability you can define a source-port filter once and apply it

to multiple ports and port trunks. This can make it easier to configure and

manage source-port filters on your switch. The commands to define,

configure, apply, and display the status of named source-port filters are

described below.

Operating Rules for Named Source-Port Filters

■ A port or port trunk may only have one source-port filter, named or

not named.

■ A named source-port filter can be applied to multiple ports or port

trunks.

■ Once a named source-port filter is defined, subsequent changes only

modify its action, they don’t replace it.

11-6

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General