To Next Page

To Previous Page

Configuring Port-Based and User-Based Access Control (802.1X)

Option For Authenticator Ports: Configure Port-Security To Allow Only 802.1X-Authenticated Devices

Port-Security

Note If 802.1X port-access is configured on a given port, then port-security learn-

mode for that port must be set to either continuous (the default) or port-access.

In addition to the above, to use port-security on an authenticator port (chapter

13), use the per-port client-limit option to control how many MAC addresses

of 802.1X-authenticated devices the port is allowed to learn. (Using client-limit

sets 802.1X to user-based operation on the specified ports.) When this limit is

reached, no further devices can be authenticated until a currently authenti-

cated device disconnects and the current delay period or logoff period has

expired.

Configure the port access type.

Syntax: aaa port-access auth < port-list > client-limit < 1 -8>

Configures user-based 802.1X authentication on the

specified ports and sets the number of authenticated

devices the port is allowed to learn. For more on this

command, refer to “Configuring Switch Ports as 802.1X

Authenticators” on page 12-19.)

— Or —

no aaa port-access auth < port-list > client-limit

Configures port-based 802.1X authentication on the

specified ports, which opens the port. (Refer to “User

Authentication Methods” on page 12-4.)

12-48

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General