To Next Page

To Previous Page

Key Management System

Configuring Key Chain Management

KMS-Related CLI Commands in This Section Page

show key-chain < chain_name > page 15-3

[ no ] key-chain chain_name page 15-3

[ no ] key-chain chain_name key Key_ID page 15-4

The Key Management System (KMS) has three configuration steps:

1. Create a key chain entry.

2. Assign a time-independent key or set of time-dependent keys to the Key

Chain entry. The choice of key type is based on the level of security

required for the protocol to which the key entry will be assigned.

3. Assign the key chain to a KMS-enabled protocol.

This procedure is protocol-dependent. For information on a specific protocol,

refer to the chapter covering that protocol in the Management and Configu-

ration Guide for your switch.

Creating and Deleting Key Chain Entries

To use the Key Management System (KMS), you must create one or more key

chain entries. An entry can be the pointer to a single time-independent key or

a chain of time-dependent keys.

Note The key chain information is copied to the standby management module (if

redundancy is enabled and the standby module has passed self-test).

Syntax: [ no ] key-chain < chain_name >

Generate or delete a key chain entry. Using the

optional no form of the command deletes the key

chain. The < chain_name > parameter can include up

to 32 characters.

15-3

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General