To Next Page

To Previous Page

IPv4 Access Control Lists (ACLs)

Displaying ACL Configuration Data

Display the Content of All ACLs on the Switch

This command lists the configuration details for the IPv4 ACLs in the running-

config file.

Syntax: show access-list config

List the configured syntax for all IPv4 ACLs currently config-

ured on the switch.

Note Notice that you can use the output from this command for input to an offline

text file in which you can edit, add, or delete ACL commands. Refer to

“Creating or Editing ACLs Offline” on page 9-94.

This information also appears in the show running display. If you executed write

memory after configuring an ACL, it appears in the show config display.

For example, with two ACLs configured in the switch, you will see results

similar to the following:

ProCurve(config)# show access-list config

ip access-list standard "List-43"

10 deny 10.28.236.77 0.0.0.0

20 deny 10.29.140.107 0.0.0.0

30 permit 0.0.0.0 255.255.255.255

exit

ip access-list extended "111"

10 permit tcp 10.30.133.27 0.0.0.0 0.0.0.0 255.255.255.255

20 permit tcp 10.30.155.101 0.0.0.0 0.0.0.0 255.255.255.255

30 deny ip 10.30.133.1 0.0.0.0 0.0.0.0 255.255.255.255 log

40 deny ip 10.30.155.1 0.0.0.255 0.0.0.0 255.255.255.255

exit

Figure 9-28. Example of an ACL Configured Syntax Listing

9-87

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General