To Next Page

To Previous Page

Configuring Username and Password Security

Configuring Local Password Security

Menu: Setting Passwords

As noted earlier in this section, usernames are optional. Configuring a user-

name requires either the CLI or the web browser interface.

1. From the Main Menu select:

3. Console Passwords

Figure 2-1. The Set Password Screen

2. To set a new password:

a. Select Set Manager Password or Set Operator Password. You will then

be prompted with Enter new password.

b. Type a password of up to 16 ASCII characters with no spaces and

press [Enter]. (Remember that passwords are case-sensitive.)

c. When prompted with Enter new password again, retype the new pass-

word and press [Enter].

After you configure a password, if you subsequently start a new console

session, you will be prompted to enter the password. (If you use the CLI or

web browser interface to configure an optional username, the switch will

prompt you for the username, and then the password.)

2-6

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General