To Next Page

To Previous Page

Configuring Username and Password Security

Overview

Feature Default Menu CLI Web

Set Usernames none — — page 2-9

Set a Password none page 2-6 page 2-8 page 2-9

Delete Password Protection n/a page 2-7 page 2-8 page 2-9

show front-panel-security

n/a — page 1-13 —

front-panel-security

— page 1-13 —

password-clear

enabled — page 1-13 —

reset-on-clear

disabled — page 1-14 —

factory-reset

enabled — page 1-15 —

password-recovery

enabled — page 1-15 —

Console access includes both the menu interface and the CLI. There are two

levels of console access: Manager and Operator. For security, you can set a

password pair (username and password) on each of these levels.

Notes Usernames are optional. Also, in the menu interface, you can configure

passwords, but not usernames. To configure usernames, use the CLI or the

web browser interface.

Usernames and passwords for Manager and Operator access can also be

configured using SNMP. For more information, refer to “Using SNMP To View

and Configure Switch Authentication Features” on page 5-21.

Beginning with software release W.14.xx, usernames and passwords for Man-

ager and Operator access can also be configured using the Management

Interface Wizard. For more information, refer to “Quick Start: Using the

Management Interface Wizard” on page 1-11.

2-3

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General