IPv4 Access Control Lists (ACLs)
Deleting an ACL
ProCurve(config)# interface b10 ip access-group My-List in
ProCurve(config)# interface b10
ProCurve(eth-b10)# ip access-group 155 in
Enables a static port ACL
ProCurve(eth-b10)# exit
from a port context.
ProCurve(config)# no interface b10 ip access-group My-List in
Disables a static port ACL
from the Global
ProCurve(config)# interface b10
Configuration level.
ProCurve(eth-b10)# no ip access-group 155 in
ProCurve(eth-b10)# exit
Uses a VLAN context to
disable a static port ACL.
Enables a static port ACL
from the Global
Configuration level.
Figure 9-15. Methods for Enabling and Disabling ACLs
Deleting an ACL
Syntax: no ip access-list standard < name-str | 1-99 >
no ip access-list extended < name-str | 100-199 >
no access-list < 1 - 99 | 100 - 199 >
Removes the specified ACL from the switch’s running-
config file.
Note: Deleting an ACL does not delete any assignment of
that ACL’s identifier on a specific interface. Creating a new
ACL using an identifier that is already configured on an
interface causes the switch to automatically activate that
ACL. If you need to remove an ACL identifier assignment
on an interface, refer to “Adding or Removing an ACL
Assignment On an Interface” on page 9-73
9-74
To Next Page
Loading...
Need help?
General
