To Next Page

To Previous Page

Web and MAC Authentication

Configuring MAC Authentication on the Switch

Configuring MAC Authentication on the

Switch

Overview

1. If you have not already done so, configure a local username and password

pair on the switch.

2. If you plan to use multiple VLANs with MAC Authentication, ensure that

these VLANs are configured on the switch and that the appropriate port

assignments have been made.

3. Use the ping command in the switch console interface to ensure that the

switch can communicate with the RADIUS server you have configured to

support MAC-Auth on the switch.

4. Configure the switch with the correct IP address and encryption key to

access the RADIUS server.

5. Configure the switch for MAC-Auth:

a. Configure MAC Authentication on the switch ports you want to use.

6. Test both the authorized and unauthorized access to your system to

ensure that MAC Authentication works properly on the ports you have

configured for port-access.

3-32

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General