To Next Page

To Previous Page

RADIUS Authentication and Accounting

Configuring the Switch for RADIUS Authentication

[key < key-string >]

Optional. Specifies an encryption key for use during

authentication (or accounting) sessions with the specified

server. This key must match the encryption key used on

the RADIUS server. Use this command only if the specified

server requires a different encryption key than configured

for the global encryption key.

Note: Formerly, when you saved the configuration file

using Xmodem or TFTP, the RADIUS encryption key infor-

mation was not saved in the file. This caused RADIUS

authentication to break when the startup configuration

file was loaded back onto the switch. You now can save the

configured RADIUS shared secret (encryption) key to a

configuration file by entering the following commands:

include-credentials

write memory

For more information, see “Saving Security Credentials

in a Config File” on page 2-10 in this guide.

no radius-server host < ip-address > key

Use the no form of the command to remove the key for a

specified server.

For example, suppose you have configured the switch as shown in figure 5-4

and you now need to make the following changes:

1. Change the encryption key for the server at 10.33.18.127 to “source0127”.

2. Add a RADIUS server with an IP address of 10.33.18.119 and a server-

specific encryption key of “source0119”.

5-16

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General