To Next Page

To Previous Page

Configuring RADIUS Server Support for Switch Services

Configuring and Using RADIUS-Assigned Access Control Lists

Syntax: show port-access authenticator < port-list >

For ports, in < port-list > that are configured for authentication, this command indicates

whether there are any RADIUS-assigned features active on the port(s). (Any ports in

< port-list > that are not configured for authentication do not appear in this listing.)

Port: Port number of port configured for authentication.

Auth Clients: Number of authorized clients

Unauth Clients: Number of unauthorized clients

Untagged VLAN: VLAN IDs (VIDs) of the untagged VLANs currently supporting the authenti-

cated connection.

Tagged VLANs: VLAN IDs (VIDs) of the tagged VLANs currently supporting the authenticated

connection

Port CoS: Indicates the status of the current 802.1p priority setting for inbound traffic.

No-override: Indicates that no RADIUS-assigned 802.1p priority is currently active on

the indicated port. (For more on traffic prioritization for the switches covered in this

guide, refer to the chapter titled “Quality of Service (QoS): Managing Bandwidth More

Effectively”, in the Advanced Traffic Configuration Guide.)

0 - 7: Indicates that the displayed 802.1p priority has been assigned by a RADIUS server

to inbound traffic on the indicated port for a currently active, authenticated client

session. This assignment remains active until the session ends.

Kbps In Limit: Indicates the ingress rate-limit assigned by the RADIUS server to the port for

traffic inbound from the authenticated client. If there is no ingress rate-limit assigned, then

Not Set appears in this field.

RADIUS ACL: Indicates whether a RADIUS-assigned ACL is currently active on the port.

Yes: An ACL has been assigned by a RADIUS server to inbound traffic on the indicated

port for a currently active, authenticated client session. This assignment remains

active until the session ends.

No: There is no RADIUS-assigned ACL currently active on the indicated port.

Cntrl Dir: Directions in which flow of incoming and outgoing traffic is blocked on 802.1X-

aware port that has not yet entered the authenticated state:

Both: Incoming and outgoing traffic is blocked on port until authentication occurs.

In: Only incoming traffic is blocked on port before authentication occurs. Outgoing traffic

with unknown destination addresses is flooded on the unauthenticated 802.1X-aware port.

6-27

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General