To Next Page

To Previous Page

Configuring Secure Socket Layer (SSL)

Configuring the Switch for SSL Operation

that involves having the certificate authority verify the certificate request and

then digitally signing the request to generate a certificate response (the usable

server host certificate). The third phase is the download phase consisting of

pasting to the switch web server the certificate response, which is then

validated by the switch and put into use by enabling SSL

To generate a certificate request from the web browser interface:

i. Select the Security tab, then select the

[SSL] button

ii. Select the Create Certificate/Certificate Request radio button.

iii. Select Create CA Request from the Certificate Type drop-down list.

iv. Select the key size from the RSA Key Size drop-down list. If you

wish to re-use the current certificate key, select Current from the

RSA Key Size drop-down list.

v. Fill in remaining certificate arguments (Refer to “Comments on

Certificate Fields.” on page 8-10.)

vi. Click on

[Apply Changes] to create the certificate request. A new

web browser page appears, consisting of two text boxes. The

switch uses the upper text box for the certificate request text. The

lower text box appears empty. You will use it for pasting in the

certificate reply after you receive it from the certificate authority.

(This authority must return a non- PEM encoded certificate

request reply.

vii. After the certificate authority processes your request and sends

you a certificate reply (that is, an installable certificate), copy and

paste it into the lower text box.

viii. Click on the

[Apply Changes] button to install the certificate.

8-16

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General