To Next Page

To Previous Page

IPv4 Access Control Lists (ACLs)

Overview

• The CLI remark command option allows you to enter a separate

comment for each ACE.

■ A source or destination IPv4 address and a mask, together, can define

a single host, a range of hosts, or all hosts.

■ Every ACL populated with one or more explicit ACEs includes an

Implicit Deny as the last entry in the list. The switch applies this action

to any packets that do not match other criteria in the ACL. (For

standard ACLs, the Implicit Deny is deny any. For extended ACLs, it

is deny ip any any.)

■ In any ACL, you can apply an ACL log function to ACEs that have an

explicit “deny” action. The logging occurs when there is a match on

a “deny” ACE (except when the ACL is used for mirroring). The switch

sends ACL logging output to Syslog, if configured, and, optionally, to

a console session.

You can create ACLs for the switch configuration using either the CLI or a text

editor. The text-editor method is recommended when you plan to create or

modify an ACL that has more entries than you can easily enter or edit using

the CLI alone. Refer to “Creating or Editing ACLs Offline” on page 9-94.

9-17

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General