HP PROCURVE 2910AL User Manual

IPv4 Access Control Lists (ACLs)
Overview
For more details on ACL planning considerations, refer to “Planning an ACL
Application” on page 9-24.
Caution Regarding
the Use of Source
Routing
Source routing is enabled by default on the switch and can be used to override
ACLs. For this reason, if you are using ACLs to enhance network security, the
recommended action is to use the no ip source-route command to disable
source routing on the switch. (If source routing is disabled in the running-
config file, the show running command includes “no ip source-route” in the
running-config file listing.)
9-19

HP PROCURVE 2910AL Specifications

General

Model	HP ProCurve 2910al
Switching Capacity	128 Gbps
Throughput	95.2 Mpps
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
Manageable	Yes
Power	100-240 VAC
Power Supply	Internal
Operating Temperature	0°C to 45°C (32°F to 113°F)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF
Features	IPv6, VLAN, QoS, ACLs
Operating Humidity	15% to 95% non-condensing
Uplink Ports	4
Power over Ethernet	Yes (PoE+ models available)