To Next Page

To Previous Page

Configuring Port-Based and User-Based Access Control (802.1X)

Configuring Switch Ports as 802.1X Authenticators

[reauth-period < 0 - 9999999 >]

Sets the period of time after which clients connected

must be re-authenticated. When the timeout is set to 0

the reauthentication is disabled (Default: 0 second)

[unauth-vid < vlan-id >]

Configures an existing static VLAN to be the Unautho-

rized-Client VLAN. This enables you to provide a path

for clients without supplicant software to download the

software and begin an authentication session. Refer to

“802.1X Open VLAN Mode” on page 12-31.

aaa port-access authenticator < port-list >

[logoff-period]< 1 - 999999999 >

Configures the period of time the switch waits for

client activity before removing an inactive client from

the port. (Default: 300 seconds)

[unauth-period < 0-255 >]

Specifies a delay in seconds for placing a port on the

Unauthorized-Client VLAN. This delay allows more

time for a client with 802.1X supplicant capability to

initiate an authentication session. If a connected cli-

ent does not initiate a session before the timer expires,

the port is assigned to the Unauthenticated-Client

VLAN. (Default: 0 seconds)

[auth-vid < vid >]

Configures an existing, static VLAN to be the Autho-

rized-Client VLAN. Refer to “802.1X Open VLAN Mode”

on page 12-31.

12-25

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General