To Next Page

To Previous Page

Configuring Port-Based and User-Based Access Control (802.1X)

802.1X Open VLAN Mode

802.1X Per-Port Configuration Port Response

Authorized-Client VLAN • After client authentication, the port drops membership in the

Unauthorized-Client VLAN and becomes an untagged member of

this VLAN.

Notes: If the client is running an 802.1X supplicant application

when the authentication session begins, and is able to

authenticate itself before the switch assigns the port to the

Unauthorized-Client VLAN, then the port does not become a

member of the Unauthorized-Client VLAN. On the switches

covered in this guide, you can use the unauth-period command—

page 12-25—to delay moving the port into the Unauthorized-Client

VLAN.

If RADIUS authentication assigns a VLAN and there are no other

authenticated clients on the port, then the port becomes a member

of the RADIUS-assigned VLAN —instead of the Authorized-Client

VLAN—while the client is connected.

• If the port is statically configured as a tagged member of a VLAN,

and this VLAN is used as the Authorized-Client VLAN, then the port

temporarily becomes an untagged member of this VLAN when the

client becomes authenticated.

• If the port is statically configured as a tagged member of a VLAN,

the port returns to tagged membership in this VLAN upon

successful authentication. This happens even if the RADIUS

server assigns the port to another, authorized VLAN. If the port is

already configured as a tagged member of a VLAN that RADIUS

assigns as an authorized VLAN, then the port becomes an

untagged member of that VLAN for the duration of the client

connection.

12-35

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General