HP PROCURVE 2910AL

Configuring Port-Based and User-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
ProCurve(config)# show port-access authenticator 2-3
Port Access Authenticator Status
Port-access authenticator activated [No] : No
Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : No
Auth Unauth Untagged Tagged Kbps In RADIUS Cntrl
Port Clients Clients VLAN VLANs Port COS Limit ACL Dir
---- -------- -------- -------- ------ --------- ----------- ------ -----
2 1 0 1 7 90 No In
3 1 0 1 5 50 Yes In
Figure 12-10. Example of show port-access authenticator Command
The information displayed with the show port-access authenticator command
for individual (config | statistics | session-counters | vlan | clients) options is
described below.
12-55