To Next Page

To Previous Page

Configuring Port-Based and User-Based Access Control (802.1X)

Displaying 802.1X Configuration, Statistics, and Counters

Syntax: show port-access authenticator vlan [port-list]

Displays the following information on the VLANs configured

for use in 802.1X port-access authentication on all switch

ports, or specified ports, that are enabled as 802.1X authen-

ticator:

• Authentication mode used on each port, configured with

the aaa port-access authenticator control command (see page

12-22)

• VLAN ID (if any) to be used for traffic from 802.1X-

authenticated clients

• VLAN ID (if any) to be used for traffic from

unauthenticated clients

802.1X configuration information for ports that are not

enabled as an 802.1X authenticators is not displayed.

ProCurve(config)# show port-access authenticator vlan

Port Access Authenticator VLAN Configuration

Port-access authenticator activated [No] : Yes

Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : No

Access Unauth Auth

Port Control VLAN ID VLAN ID

---- -------- -------- ------- -

2 Auto 0 0

Figure 12-14.Example of show port-access authenticator vlan Command

12-59

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General