HP PROCURVE 2910AL User Manual

Configuring and Monitoring Port Security
Port Security
Displaying Port Security Settings.
Syntax: show port-security
show port-security <port number>
show port-security [<port number>-<port number>]. . .[,<port number>]
The CLI uses the same command to provide two types of port
security listings:
• All ports on the switch with their Learn Mode and (alarm)
Action
• Only the specified ports with their Learn Mode, Address
Limit, (alarm) Action, and Authorized Addresses
Without port parameters,
show port-security displays Operating
Control settings for all ports on a switch.
Figure 13-2. Example Port Security Listing (Ports A7 and A8 Show the Default
Setting)
With port numbers included in the command, show port-security displays Learn
Mode, Address Limit, (alarm) Action, and Authorized Addresses for the spec-
ified ports on a switch. The following example lists the full port security
configuration for a single port:
13-9

HP PROCURVE 2910AL Specifications

General

Model	HP ProCurve 2910al
Switching Capacity	128 Gbps
Throughput	95.2 Mpps
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
Manageable	Yes
Power	100-240 VAC
Power Supply	Internal
Operating Temperature	0°C to 45°C (32°F to 113°F)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF
Features	IPv6, VLAN, QoS, ACLs
Operating Humidity	15% to 95% non-condensing
Uplink Ports	4
Power over Ethernet	Yes (PoE+ models available)