EasyManuals Logo

HP PROCURVE 2910AL User Manual

HP PROCURVE 2910AL
594 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #537 background imageLoading...
Page #537 background image
Configuring and Monitoring Port Security
Port Security
Removing a Device From the “Authorized” List for a Port. This
command option removes unwanted devices (MAC addresses) from the
Authorized Addresses list. (An Authorized Address list is available for each
port for which Learn Mode is currently set to “Static”. Refer to the command
syntax listing under “Configuring Port Security” on page 13-12.)
Caution When learn mode is set to static, the Address Limit (address-limit) parameter
controls how many devices are allowed in the Authorized Addresses (mac-
address) for a given port. If you remove a MAC address from the Authorized
Addresses list without also reducing the Address Limit by 1, the port may
subsequently detect and accept as authorized a MAC address that you do not
intend to include in your Authorized Address list. Thus, if you use the CLI to
remove a device that is no longer authorized, it is recommended that you first
reduce the Address Limit (address-limit) integer by 1, as shown below. This
prevents the possibility of the same device or another unauthorized device on
the network from automatically being accepted as “authorized” for that port.
To remove a device (MAC address) from the “Authorized” list and when the
current number of devices equals the Address Limit value, you should first
reduce the Address Limit value by 1, then remove the unwanted device.
Note You can reduce the address limit below the number of currently authorized
addresses on a port. This enables you to subsequently remove a device from
the “Authorized” list without opening the possibility for an unwanted device
to automatically become authorized.
For example, suppose port A1 is configured as shown below and you want to
remove 0c0090-123456 from the Authorized Address list:
When removing 0c0090-123456, first
reduce the Address Limit by 1 to prevent
the port from automatically adding
another device that it detects on the
network.
Figure 13-8. Example of Two Authorized Addresses on Port A1
13-21

Table of Contents

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

HP PROCURVE 2910AL Specifications

General IconGeneral
ModelHP ProCurve 2910al
Switching Capacity128 Gbps
Throughput95.2 Mpps
ManagementWeb, CLI, SNMP
Jumbo Frame SupportYes
ManageableYes
Power100-240 VAC
Power SupplyInternal
Operating Temperature0°C to 45°C (32°F to 113°F)
StackingYes
MAC Address Table Size32000 entries
Routing ProtocolRIP, OSPF
FeaturesIPv6, VLAN, QoS, ACLs
Operating Humidity15% to 95% non-condensing
Uplink Ports4
Power over EthernetYes (PoE+ models available)

Related product manuals