To Next Page

To Previous Page

Configuring Username and Password Security

Saving Security Credentials in a Config File

the username and password used as 802.1X authentication credentials for

access to the switch. You can store the password port-access values in the

running configuration file by using the include-credentials command.

Note that the password port-access values are configured separately from

local operator username and passwords configured with the password

operator command and used for management access to the switch. For

more information about how to use the password port-access command

to configure operator passwords and usernames for 802.1X authentica-

tion, see “Do These Steps Before You Configure 802.1X Operation” on page

12-15 in this guide.

2-22

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General