HP ProCurve 5400zl

Range: < 5 to 300 >
helper-address
■ [no] interface vlan VLAN-ID ip helper-address IP-ADDR
Usage: [no] ip helper-address IP-ADDR
Description: Add or remove a DHCP server IP address for the VLAN. The
DHCP requests received by the switch on this VLAN are to
be relayed to the specied DHCP server.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
high-priority-forward
■ [no] interface vlan VLAN-ID ip igmp high-priority-forward
Usage: [no] ip igmp high-priority-forward
Description: Enable/disable the high priority forwarding of trafc for
subscribed IP Multicast groups. This feature is congured on
a per-VLAN basis.
holdtime
■ interface vlan VLAN-ID ip irdp holdtime < 4 to 9000 >
Usage: [no] ip irdp holdtime <4-9000>
Description: Set the lifetime (in seconds) of the router advertisements sent
on this interface. Must be no less than the maximum time
allowed between sending unsolicited router advertisements.
Range: < 4 to 9000 >
host
■ interface vlan VLAN-ID connection-rate-filter unblock host IP-ADDR
Match packets from the specied IP address.
■ interface svlan VLAN-ID connection-rate-filter unblock host IP-ADDR
Match packets from the specied IP address.
icmp
■ [no] interface [ETHERNET] PORT-LIST rate-limit icmp
Set limits for ICMP trafc only.
Next Available Options:
■ percent < 0 to 100 > -- Specify limit as percent of inbound or outbound traffic.(p. 258)
■ kbps < 0 to 10000000 > -- Specify kilobits-per-second limit of allowed ICMP traffic (values should
be at least 13Kbps, or max-length ICMP packets will fail.) (p. 246)
237© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide