HP ProCurve 5400zl

irdp
■ [no] interface vlan VLAN-ID ip irdp
Usage: [no] ip irdp [...]
Description: Congure ICMP Router Discovery Protocol (IRDP). This is
a VLAN context command. It can be called directly from the VLAN
context or may follow the 'vlan VLAN-ID' command prex.
Called without parameters the command enables or disables (if
preceded by 'no') the protocol on the VLAN specied, or
identied by the current VLAN context. Use 'ip irdp ?' to get
a list of all possible congurable parameters.
Next Available Options:
■ advert-address < multicast | broadcast > -- Specify the destination address to be used for router
advertisements(p. 219)
■ holdtime < 4 to 9000 > -- Set the lifetime (in seconds) of the router advertisements sent on this
interface(p. 237)
■ maxadvertinterval < 4 to 1800 > -- Set the maximum time (in seconds) allowed between sending
unsolicited router advertisements(p. 249)
■ minadvertinterval < 3 to 1800 > -- Set the minimum time (in seconds) allowed between sending
unsolicited router advertisements(p. 250)
■ preference -- The preferability of the router as a default router, relative to the other routers on
the same subnet(p. 264)
join-timer
■ interface [ETHERNET] PORT-LIST gvrp join-timer < 20 to 75 >
Set join timer value (centiseconds; default 20).
Range: < 20 to 75 >
jumbo
■ [no] interface vlan VLAN-ID jumbo
Usage: [no] jumbo
Description: Labels this VLAN as a Jumbo VLAN, allowing you to pass
packets up to 9220 bytes in size.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
■ [no] interface svlan VLAN-ID jumbo
Usage: [no] jumbo
Description: Labels this VLAN as a Jumbo VLAN, allowing you to pass
packets up to 9220 bytes in size.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
kbps
■ interface [ETHERNET] PORT-LIST rate-limit icmp kbps < 0 to 10000000 >
246© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide