To Next Page

To Previous Page

■ 3des-cbc

■ aes192-cbc

■ aes256-cbc

■ rijndael-cbc@lysator.liu.se

■ aes128-ctr

■ aes192-ctr

■ aes256-ctr

connection-rate-filter

■ [no] ip access-list connection-rate-filter

Congure a connection-rate-lter Access Control List.

Next Available Option:

■ name -- Specify name of Access Control List to configure. (ASCII-STR) (p. 304)

default

■ ip ssh port default

Specify that the daemon should listen on the default TCP port (22).

default-gateway

■ [no] ip default-gateway

Usage: [no] ip default-gateway [IP-ADDR]

Description: Congure the IPv4 default gateway address, which will be

used when routing is not enabled on the switch. The IP-ADDR

must be specied if the command is not preceded by 'no'.

Preceding the command with 'no' deletes the default gateway

address.The 'no' form of this command does not take

effect on default gateway address obtained via dhcp.

Next Available Option:

■ ipaddr -- IPv4 address of the default gateway. (IP-ADDR) (p. 302)

dhcp

■ ip timep dhcp

Use DHCP to acquire Timep server address.

Next Available Option:

■ interval < 1 to 9999 > -- Specify how often (in minutes) the switch tries to get the current time.(p.

301)

dhcp-bootp

■ ip address dhcp-bootp

Congure the interface to use DHCP/Bootp server to acquire parameters.

ipCommand Line Interface Reference Guide

HP ProCurve 5400zl User Manual

Other manuals for HP ProCurve 5400zl