HP ProCurve 5400zl

This command is executed at the global cong level. It congures the number
of neighbor solicitations to send when performing duplicate address detection
for a unicast address congured on a VLAN interface.
Range: 0-600 (0 = disabled)
Default: 3 (enabled)
Next Available Option:
■ number < 0 to 600 > -- Configures the number of neighbor solicitations to send when performing
duplicate address detection(p. 317)
error-interval
■ [no] ipv6 icmp error-interval
Species the time interval in milliseconds between successive token adds.
Increasing this value decreases the rate at which tokens can be added. A
setting of zero disables ICMP messaging.
Range: 0 - 2147483647
Default: 100
Next Available Option:
■ int < 0 to 2147483647 > -- Specify interval-range.(p. 316)
icmp
■ [no] ipv6 icmp
ICMPv6 rate limiting.
Next Available Option:
■ error-interval -- Send the ICMP error message.(p. 316)
incr-num
■ ipv6 access-list resequence RESEQUENCE < 1 to 2147483647 > < 1 to 2147483646 >
Specify the increment.
Range: < 1 to 2147483646 >
int
■ ipv6 icmp error-interval < 0 to 2147483647 >
Specify interval-range.
Range: < 0 to 2147483647 >
Next Available Option:
■ bucket-size -- Set the bucket size. This is optional.(p. 315)
316© 2009 Hewlett-Packard Development Company, L.P.
ipv6Command Line Interface Reference Guide