■ full
slot
■ power-over-ethernet slot SLOT-ID-RANGE
Optional - Specify a valid powered-slot list for power threshold setting or
omit to set all powered-slots.
Next Available Option:
■ threshold < 1 to 99 > -- Set the power consumption percentage at which a trap should be sent.
(NUMBER) (p. 405)
threshold
■ power-over-ethernet threshold < 1 to 99 >
Set the power consumption percentage at which a trap should be sent.
Note that the last "threshold" command affecting a given slot supersedes
the previous threshold command affecting the same slot.
Range: < 1 to 99 >
■ power-over-ethernet slot SLOT-ID-RANGE threshold < 1 to 99 >
Set the power consumption percentage at which a trap should be sent.
Range: < 1 to 99 >
405© 2009 Hewlett-Packard Development Company, L.P.
power-over-ethernetCommand Line Interface Reference Guide
To Next Page
Loading...
