HP ProCurve 5400zl

Specify the DSCP code-point in decimal.
Range: < 0 to 63 >
■ qos < udp-port | tcp-port > ip-all TCP/UDP-PORT dscp < 0 to 63 >
Specify the DSCP code-point in decimal.
Range: < 0 to 63 >
■ qos < udp-port | tcp-port > ip-all range TCP/UDP-PORT TCP/UDP-PORT dscp < 0 to 63 >
Specify the DSCP code-point in decimal.
Range: < 0 to 63 >
■ qos type-of-service diff-services < 0 to 63 > dscp < 0 to 63 >
Specify the DSCP code-point in decimal.
Range: < 0 to 63 >
■ qos type-of-service diff-services < 0 to 63 > dscp < 0 to 63 >
Specify the DSCP code-point in decimal.
Range: < 0 to 63 >
■ qos type-of-service diff-services < af11 | af12 | af13 | ... > dscp < 0 to 63 >
Specify the DSCP code-point in decimal.
Range: < 0 to 63 >
ip-addr
■ [no] qos device-priority IP-ADDR
specify the ipv4 address of the device to set the priority
Next Available Options:
■ dscp -- Specify DSCP policy to use. (p. 418)
■ priority < 0 | 1 | 2 | ... > -- Specify priority to use. (p. 428)
ip-all
■ qos < udp-port | tcp-port > ip-all
Specify range of TCP/UDP ports from [to] which to prioritize trafc.
Next Available Options:
■ port-num -- TCP/UDP port from [to] which to prioritize traffic. (TCP/UDP-PORT) (p. 427)
■ range -- Specify range of TCP/UDP ports from [to] which to prioritize traffic.(p. 432)
ip-precedence
■ qos type-of-service ip-precedence
In IP-Precedence mode, IPv4 packets are classied and given a QoS priority
based on the upper 3 bits of the IP ToS eld. The priority
association is automatic and cannot be changed:
IP-Precedence 802.1p
ToS Bits Priority
--------------------------------
111 7 (Highest)
110 6
424© 2009 Hewlett-Packard Development Company, L.P.
qosCommand Line Interface Reference Guide