â– show spanning-tree traps
Show spanning tree trap information.
trunks
â– show trunks
Usage: show trunks [[ethernet] PORT-LIST]
Description: Show a list of ports and the trunks to which they belong.
If a PORT-LIST is supplied the command shows only the ports
specied.
Next Available Option:
â– port-list -- Show the trunk information only for the ports specified. ([ethernet] PORT-LIST) (p.
578)
type
â– show ip ospf link-state type < router | network | summary | ... >
Show LSAs of the specied type only.
Supported Values:
â– router -- Show router links only.
â– network -- Show network links only.
â– summary -- Show summary links only.
â– as-summary -- Show Autonomous System summary links only.
â– external -- Show Autonomous System external links only.
â– multicast -- Show multicast links only.
â– nssa -- Show NSSA external links only.
â– show ip route < static | connected | rip | ... >
Specify type of routes to display.
Supported Values:
â– static -- Show static routes only.
â– connected -- Show the switch's interface routes only.
â– rip -- Show RIP routes only.
â– ospf -- Show OSPF routes only.
â– show ipv6 route < connected >
Specify type of routes to display.
Supported Values:
â– connected -- Show the switch's interface routes only.
â– show statistics < aclv4 >
Supported Values:
â– aclv4 -- Ipv4 acl.
Next Available Option:
â– acl-name -- Enter the name of acl/policy. (ASCII-STR) (p. 528)
600© 2009 Hewlett-Packard Development Company, L.P.
showCommand Line Interface Reference Guide