following syntax:
ipv6 address 1234:abcd::5678/40
ipv6 address 2001:0db8:1:1:ffff:ffff:ffff:fffe/64 anycast
ipv6 address 2001:0db8:0:1::/64 eui-64
Only link-local addreses are conîš¿gured without PREFIX-LEN as below:
ipv6 address FE80:0:0:0:0123:0456:0789:0abc link-local
Multiple addresses may be conîš¿gured on a single VLAN.
Next Available Options:
â– autoconfig -- Automatic address configuration.(p. 665)
â– dhcp -- Configure a DHCPv6 client.(p. 666)
â– ipv6-addr -- Configure a link-local IPv6 address. (IPV6-ADDR) (p. 668)
â– ipv6-addr/mask -- Configure IPv6 address represented in CIDR notation.
(IPV6-ADDR/PREFIX-LEN) (p. 668)
all
â– svlan VLAN-ID connection-rate-filter unblock all
Resets all previously blocked by the connection rate îš¿lter
â– svlan VLAN-ID monitor all < In | Out | Both >
Monitor all trafîš¿c.
Supported Values:
â– In -- Monitor all inbound traffic
â– Out -- Monitor all outbound traffic
â– Both -- Monitor all inbound and outbound traffic
Next Available Option:
â– mirror -- Mirror destination.(p. 669)
anycast
â– [no] svlan VLAN-ID ipv6 address IPV6-ADDR/PREFIX-LEN anycast
Address that is assigned to a set of interfaces that typically belong to different
nodes
auto
â– svlan VLAN-ID auto [ETHERNET] PORT-LIST
Usage: [no] auto [ethernet] PORT-LIST
Description: Cause each port identiîš¿ed in the port list to learn its
VLAN membership using the GARP VLAN Registration Protocol
(GVRP). This command is only valid when GVRP is enabled.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
autoconfig
â– [no] svlan VLAN-ID ipv6 address autoconfig
665© 2009 Hewlett-Packard Development Company, L.P.
svlanCommand Line Interface Reference Guide
To Next Page
Loading...
Need help?
General