HP ProCurve 5400zl

■ rip-compatible < V1-only | V2-only | V1-or-V2 > -- Define RIP version for incoming and outgoing
packets.(p. 747)
■ vlan VLAN-ID connection-rate-filter unblock all
Resets all previously blocked by the connection rate lter
■ vlan VLAN-ID monitor all < In | Out | Both >
Monitor all trafc.
Supported Values:
■ In -- Monitor all inbound traffic
■ Out -- Monitor all outbound traffic
■ Both -- Monitor all inbound and outbound traffic
Next Available Option:
■ mirror -- Mirror destination.(p. 735)
any
■ vlan VLAN-ID ip pim-dense ip-addr any
Dynamically determine IP address.
■ vlan VLAN-ID ip pim-sparse ip-addr any
Dynamically determine IP address.
anycast
■ [no] vlan VLAN-ID ipv6 address IPV6-ADDR/PREFIX-LEN anycast
Address that is assigned to a set of interfaces that typically belong to different
nodes
area
■ vlan VLAN-ID ip ospf area
Specify an OSPF area.
Next Available Options:
■ area-id -- Single integer or IP address style dotted decimal. (OSPF-AREA-ID) (p. 717)
■ backbone -- The backbone area (the same as 0.0.0.0).(p. 719)
■ vlan VLAN-ID ip ospf IP-ADDR area
Specify an OSPF area.
Next Available Options:
■ area-id -- Single integer or IP address style dotted decimal. (OSPF-AREA-ID) (p. 717)
■ backbone -- The backbone area (the same as 0.0.0.0).(p. 719)
716© 2009 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide