HP ProCurve 5400zl User Manual

Usage: [no] ip irdp <multicast|broadcast>
Description: Specify the destination address to be used for router
advertisements.
It has to be either multicast or broadcast. If the value
of this object is 'multicast' (the default), router
advertisements will be sent to the all-hosts multicast
address, 224.0.0.1. If the value of this object is 'broadcast',
router advertisements sent on this interface will be sent to
the limitied broadcast address, 255.255.255.255.
Supported Values:
■ multicast -- Send advertisements to all-hosts multicast address.
■ broadcast -- Send advertisements to broadcast address.
advertise-interval
■ vlan VLAN-ID vrrp vrid < 1 to 255 > advertise-interval < 1 to 255 >
Usage: vrrp vrid <VRID> advertise-interval <1-255>
Description: Set time interval (in seconds) between sending VRRP advertisement
messages. The default value is one second.
Range: < 1 to 255 >
all
■ [no] vlan VLAN-ID ip ospf all
Process the request for all IP addresses.
Next Available Options:
■ passive -- Configures an ospf interface as passive. (p. 739)
■ area -- Specify an OSPF area.(p. 716)
■ authentication-key -- Set simple authentication method and key.(p. 717)
■ authentication -- Disable authentication.(p. 717)
■ md5-auth-key-chain -- Set MD5 authentication method and key chain.(p. 734)
■ cost < 1 to 65535 > -- Set metric of this interface.(p. 721)
■ dead-interval < 1 to 65535 > -- Set dead interval in seconds; the default is 40.(p. 721)
■ hello-interval < 1 to 65535 > -- Set hello interval in seconds; the default is 10.(p. 725)
■ priority < 0 to 255 > -- Set priority of this router as a designated router.(p. 742)
■ retransmit-interval < 1 to 3600 > -- Set retransmit interval in seconds; the default is 5.(p. 746)
■ transit-delay < 1 to 3600 > -- Set transit delay in seconds; the default is 1.(p. 749)
■ [no] vlan VLAN-ID ip rip all
Process the request for all IP addresses.
Next Available Options:
■ authentication-type < none | text > -- Set authentication type used on this interface.(p. 718)
■ authentication-key -- Set RIP authentication key (maximum 16 characters).(p. 717)
■ metric < 1 to 15 > -- Set metric for this interface.(p. 734)
■ poison-reverse -- Enable/disable poison reverse on this interface.(p. 741)
■ receive < V1-only | V2-only | V1-or-V2 | ... > -- Define RIP version for incoming packets.(p. 745)
■ send < disabled | V1-only | V1-compatible-V2 | ... > -- Define RIP version for outgoing packets.(p.
747)
715© 2009 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide

HP ProCurve 5400zl Specifications

General

Brand	HP
Model	ProCurve 5400zl
Category	Switch
Language	English