Range: < 1 to 600 >
preempt-mode
â– [no] vlan VLAN-ID vrrp vrid < 1 to 255 > preempt-mode
Usage: [no] vrrp vrid <VRID> preempt-mode
Description: Enable/disable preempt mode for the virtual router instance.
The default value is 'enabled'.
preference
â– vlan VLAN-ID ip irdp preference
Usage: [no] ip irdp preference <no-default|<-2147483647-2147483647>>
Description: The preferability of the router as a default
router, relative to the other routers on the same
subnet. Higher values are more preferable.
Next Available Options:
â– number < -2147483647 to 2147483647 > -- The router preferability number. Higher values are
more preferable.(p. 738)
â– no-default -- Indicates that the router should never be used as a default by its neighbors.(p.
737)
primary-ip-address
â– vlan VLAN-ID vrrp vrid < 1 to 255 > primary-ip-address
Usage: [no] vrrp vrid <VRID> primary-ip-address <IP-ADDR | lowest>
Description: Specify IP address the virtual router instance will use as
a source in VRRP advertisement messages. If not set (i.e. is
'0.0.0.0') the virtual router uses numerically lowest IP address
of the VLAN. The default value is 'lowest'.
Next Available Options:
â– ip-addr -- Specify IP address. (IP-ADDR) (p. 729)
â– lowest -- Dynamically determine lowest IP address.(p. 733)
priority
â– vlan VLAN-ID ip ospf priority < 0 to 255 >
Set priority of this router as a designated router.
Range: < 0 to 255 >
â– vlan VLAN-ID ip ospf IP-ADDR priority < 0 to 255 >
Set priority of this router as a designated router.
Range: < 0 to 255 >
â– vlan VLAN-ID ip ospf all priority < 0 to 255 >
Set priority of this router as a designated router.
742© 2009 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide
To Next Page
Loading...
Need help?
General