HP ProCurve 5400zl User Manual

poison-reverse
■ [no] vlan VLAN-ID ip rip poison-reverse
Enable/disable poison reverse on this interface.
■ [no] vlan VLAN-ID ip rip IP-ADDR poison-reverse
Enable/disable poison reverse on this interface.
■ [no] vlan VLAN-ID ip rip all poison-reverse
Enable/disable poison reverse on this interface.
port-name
■ [no] vlan VLAN-ID ip forward-protocol udp IP-ADDR < dns | ntp | netbios-ns | ... >
Supported Values:
■ dns -- Domain Name Service (53)
■ ntp -- Network Time Protocol (123)
■ netbios-ns -- NetBIOS Name Service (137)
■ netbios-dgm -- NetBIOS Datagram Service (138)
■ radius -- Remote Authentication Dial-In User Service (1812)
■ radius-old -- Remote Authentication Dial-In User Service (1645)
■ rip -- Routing Information Protocol (520)
■ snmp -- Simple Network Management Protocol (161)
■ snmp-trap -- Simple Network Management Protocol (162)
■ tftp -- Trivial File Transfer Protocol (69)
■ timep -- Time Protocol (37)
port-num
■ [no] vlan VLAN-ID ip forward-protocol udp IP-ADDR TCP/UDP-PORT
UDP port number of the server.
preempt-delay-time
■ [no] vlan VLAN-ID vrrp vrid < 1 to 255 > preempt-delay-time < 1 to 600 >
Usage: [no] vrrp vrid <VRID> preempt-delay-time <1-600>
Description: Allows you to specify a time in seconds that the Owner router
will wait before taking control of the virtual IP address and
beginning to route packets. You can congure the time on VRRP
Owner and Backup routers.
The "no" form of the command may be used to disable the
pre-emptive delay timer.
Note: If you have congured the Preempt Delay Timer with a non-zero
value, you must use the "no" form of the command to change it
to zero.
Parameters:
o preempt-delay-time <1-600> - The number of seconds to delay.
741© 2009 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide

HP ProCurve 5400zl Specifications

General

Brand	HP
Model	ProCurve 5400zl
Category	Switch
Language	English