â– authentication -- Disable authentication.(p. 717)
â– md5-auth-key-chain -- Set MD5 authentication method and key chain.(p. 734)
â– cost < 1 to 65535 > -- Set metric of this interface.(p. 721)
â– dead-interval < 1 to 65535 > -- Set dead interval in seconds; the default is 40.(p. 721)
â– hello-interval < 1 to 65535 > -- Set hello interval in seconds; the default is 10.(p. 725)
â– priority < 0 to 255 > -- Set priority of this router as a designated router.(p. 742)
â– retransmit-interval < 1 to 3600 > -- Set retransmit interval in seconds; the default is 5.(p. 746)
â– transit-delay < 1 to 3600 > -- Set transit delay in seconds; the default is 1.(p. 749)
â– ip-addr -- Specify the IP address the request is for. (IP-ADDR) (p. 729)
â– all -- Process the request for all IP addresses.(p. 715)
override-interval
â– vlan VLAN-ID ip pim-dense override-interval < 500 to 6000 >
Usage: ip pim-dense override-interval <500-6000>
Description: Set the value inserted into the Override Interval îš¿eld of
a LAN Prune Delay option on this interface. Default is 2500
milliseconds.
Range: < 500 to 6000 >
â– vlan VLAN-ID ip pim-sparse override-interval < 500 to 6000 >
Usage: ip pim-sparse override-interval <500-6000>
Description: Set the value inserted into the Override Interval îš¿eld of
a LAN Prune Delay option on this interface. Default is 2500
milliseconds.
Range: < 500 to 6000 >
owner
â– vlan VLAN-ID vrrp vrid < 1 to 255 > owner
Usage: vrrp vrid <VRID> owner
Description: Designate the virtual router instance as an Owner (Master).
There is no default value.
passive
â– [no] vlan VLAN-ID ip ospf passive
Conîš¿gures an ospf interface as passive.
â– [no] vlan VLAN-ID ip ospf IP-ADDR passive
Conîš¿gures an ospf interface as passive.
â– [no] vlan VLAN-ID ip ospf all passive
Conîš¿gures an ospf interface as passive.
pim-dense
â– [no] vlan VLAN-ID ip pim-dense
739© 2009 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide
To Next Page
Loading...
Need help?
General