For more information, see “Establishing a logical path” (page 112).
• The Remote DKC Control Function environment (route list definition and command device
registration) is defined.
To confirm this, check the definition in the Route Status panel, which is displayed from the
Manage Route panel.
For background information, see “Setting up the Remote DKC Control Function environment”
(page 115).
NOTE: The disk configuration definition file acquired by a remote scan cannot be used in other
sites.
For example, if you use a remote scan from the Primary site to acquire a disk configuration definition
file at the Secondary site and then transfer it to the Secondary site, an error results if you
subsequently specify the file in either of the following cases:
• The Local Device Address Domain ID field on the Set Defaults ISPF panel.
• The DAD parameter for the YKLOAD command.
The examples in this section refer to the configuration shown in Figure 64 (page 109).
108 Preparing to use Business Continuity Manager
To Next Page
Loading...
