3. Press the Enter key.
In the line after AC where r is specified in the Entire Route Information panel, the added entry
is displayed. Since a device number has not been specified, **** is displayed in Devn.
Defining the second route
Using the procedure from step 2 in “Defining the first entry of the route” (page 459) to “Adding an
entry (extended route definition)” (page 463), add a route from the storage system with the serial
number 90209 to the storage system with the serial number 90063.
Images for route list definitions
The following are images for when a route list is defined.
468 Using the ISPF panels
To Next Page
Loading...
