HP XP P9500 User Manual

Table 90 List of functions of Business Continuity Manager Monitor commands
FunctionCommand Name
Displays the status of Business Continuity Manager MonitorDISPLAY
Outputs the information for the copy groups whose IDs are specified in the
YKMONCG file
REPORT
Modifies the values specified in the Business Continuity Manager Monitor parameter
files after Business Continuity Manager Monitor has started
SET
Puts Business Continuity Manager Monitor to sleepSLEEP
Wakes up Business Continuity Manager MonitorWAKEUP
For the symbols used in the explanation on the format of operator commands, see “Conventions
in syntax explanations” (page 591).
NOTE:
• If it takes a long time to perform an action, there will be a long delay before the operator
command is executed.
• Business Continuity Manager Monitor can only accept a maximum of 10 operator commands.
Therefore, do not execute more than 10 operator commands in a row.
• Business Continuity Manager Monitor can retain a maximum of 50 commands waiting to be
executed. However, if the number of commands waiting to be executed exceeds 50, an error
occurs.
DISPLAY command
To display the status of Business Continuity Manager Monitor, use the MODIFY DISPLAY command.
This command allows you to display the following information.
• Values that are currently effective for the parameters specified in the YKMONOPT file
• Values that are currently effective for the parameters specified in the YKMONCG file
• Commands waiting to be executed
Format
If both the name of the cataloged procedure for startup and the identification name were specified
in the START command:
MODIFY
Δ1cataloged-procedure-for-startup-name.]identification-name
,DISPLAYΔ1{OPTIONS|CGDEF|OPCMDS}
If only the name of the cataloged procedure for startup was specified in the START command.
MODIFY
Δ1cataloged-procedure-for-startup-name
,DISPLAYΔ1{OPTIONS|CGDEF|OPCMDS}
Operands
cataloged-procedure-for-startup-name
Used to specify the name of the cataloged procedure for startup that was specified in the START
command when Business Continuity Manager Monitor was started.
identification-name
Used to specify the identification name that was specified in the START command when Business
Continuity Manager Monitor was started.
Operator commands available in BCM Monitor 521

HP XP P9500 Specifications

General

Brand	HP
Model	XP P9500
Category	Software
Language	English