10. Press the Enter key.
You are returned to the Edit Port Definition panel. The physical path is now displayed in this
panel.
Establishing a logical path
This section explains the procedure for establishing a logical path.
To establish a logical path:
1. Open the Main Menu panel, and then choose 5 Manage Path Set.
The Manage Path Set panel displays.
2. To load the path set definition file, specify l in the AC column of the target path set.
The path set definition file is loaded.
3. Check the result based on the Status column. If any problem is found, review the definition.
4. If no problem is found, specify b in the AC column of the path set to which you want to add
the established paths to establish the logical path.
456 Using the ISPF panels
To Next Page
Loading...
