HP XP P9500 - Changing a Copy Group that Is a Container to One that Is Not (Deleting a C;T Group); Defining an EXCTG

5. Press the F5=Add key.
The Setting C/T ID Attributes panel appears.
6. Specify C/T ID (JNLG) and press the Enter key (for Cnt Ac-A, the sub C/T ID (JNLG) specification
is also necessary).
The Copy Group Pair Detail panel appears (in the initial status, no display line appears).
7. Add a copy pair to the copy group.
The operations for adding a copy pair to the copy group are the same as those in section
“Adding the copy pair to the copy group (Cnt Ac-J Z)” (page 480).
Changing a copy group that is a container to one that is not (deleting a C/T group)
To delete a C/T group from a copy group container:
1. Display the Discover/Define Configuration panel and choose 4 Copy Group Definitions.
The Copy Group Detail Definition panel is displayed.
2. Specify e in AC, and then press Enter.
3. Specify d in the AC of the C/T group that you want to delete, and then press Enter.
4. Make sure that there is one C/T group in the copy group, and change Use Container from /
to a blank value.
The Copy Group Pair Detail panel is displayed.
Defining an EXCTG
This section explains how to define a Continuous Access Journal for Mainframe copy group as an
EXCTG.
Defining a copy group container 489