2. Press the F5=Add key.
The Add Path Set panel displays.
3. Specify the path set ID.
4. Press the F3=Exit key.
A path set definition file is created and the path set ID appears in the Path Set Selection List
panel.
Adding a logical path to a path set
For information about the data displayed in each ISPF panel, see the definition example in
Figure 116 (page 439).
To add a logical path to the path set:
1. Specify e in the AC column for the created path set ID, and then press the Enter key. The path
set definition file is loaded and the Path Set Detail panel displays.
440 Using the ISPF panels
To Next Page
Loading...
