2. Press the F5=Add key.
The Edit Logical Path Definition panel displays.
3. Specify DKC for Type.
4. For SHR, specify Y when sharing the target path with other logical path definitions, specify N
when not sharing the target path.
If you do not specify anything, N is assumed.
5. Specify s in the AC column of the Primary line.
The serial numbers of the scanned storage systems display in the Select Storage System panel.
6. Specify s in the AC column of the storage system serial number (14002).
7. Press the Enter key.
You are returned to the Edit Logical Path Definition panel. The values are displayed in the
S/N, Model, IFType, and PathID columns of this panel.
Creating a path set 441
To Next Page
Loading...
