HP XP P9500 - Defining the Inter-CU Logical Path Set; Adding a Logical Path to Path Set

11. Press Enter key.
You are returned to the Edit Port Definition panel. The physical path is now displayed on this
panel.
Defining the inter-CU logical path set
This section explains how to add an inter-CU logical path to the path set defined in “Defining the
inter-DKC logical path set” (page 439) to “Allocating physical paths to logical paths” (page 443),
using the inter-CU logical path definition example shown in Figure 117 (page 447).
Figure 117 Inter-CU logical path definition example
Adding a logical path to path set
To add a logical path to the path set:
Creating a path set 447